Pay4Later

Buy the DBX 1066 with INTEREST FREE FINANCE

From just £36.13 per month

DBX 1066

DBX 1066 Compressor / Limiter / Gate

    view all DBX products

    Product Code: 100083216

    Availability: Pre-Order

    £435.00
    "In the studio, broadcast facility or on the road with a P.A. system, the 1066 is designed for perfectly simple operation. The 1066 allows you to eliminate unwanted signals, flexibly control overall signal gain and guard your overall mix in dual mono or stereo operation. "
  • Input Connectors - XLR and 1/4" TRS (Pin 2 and tip hot)
  • Input Type - Electronically balanced/unbalanced, RF filtered
  • Input Impedance - Balanced > 50 kOhm, unbalanced >25 kOhm
  • Max Input - > +24 dBu balanced or unbalanced
  • CMRR - Typically >50 dB at 1 kHz
  • Output Connectors - XLR and 1/4" TRS (Pin 2 and tip hot)
  • Output Type - Servo-balanced/unbalanced, RF filtered
  • Output Impedance - Balanced 120 Ohm, unbalanced 60 Ohm
  • Max Output - > +21 dBm balanced, > +20 dBm unbalanced
  • Sidechain Input Connector - 1/4" Unbalanced (Tip-Sleeve)
  • Sidechain Input Type - Unbalanced, RF filtered
  • Sidechain Impedance - >10 kOhm
  • Sidechain Max Input Level - >+24 dBu
  • Sidechain Output Connector - 1/4" Balanced TRS (tip hot)
  • Sidechain Output Type - Impedance balanced, RF filtered
  • Sidechain Output Impedance - Balanced 2 kOhm, unbalanced 1 kOhm
  • Sidechain Max Output Level - >+21 dBu balanced or unbalanced
  • Bandwidth - 20 Hz to 20 kHz, +0/0.5 dB
  • Frequency Response - 0.35 Hz to 90 kHz, +0/-3 dB
  • Noise -
  • Dynamic Range - > 118dB, unweighted
  • THD+Noise - 0.008% typical at +4 dBu (1 kHz unity gain), 0.08% typical at +20 dBu (1 kHz unity gain),
  • IMD -
  • Interchannel Crosstalk -
  • Stereo Coupling - True RMS Power Summing
  • Compressor Threshold Range - -40 dBu to +20 dBu
  • Compressor Ratio - 1:1 to infinity:1
  • Compressor Threshold Characteristic - Selectable OverEasy® or hard knee
  • Compressor Attack/Release Characteristic - AutoDynamic
  • Compressor Attack/Release Modes - Selectable Manual or Auto
  • Compressor Manual Attack Time - Scalable program-dependent
  • Compressor Manual Release Time - Scalable program-dependent
  • Compressor Auto Attack Time - Program-dependent
  • Compressor Auto Release Time - Program-dependent
  • Compressor Output Gain - -20 to +20 dB
  • Limiter Threshold Range - +4 dBu to +24 dBu (off)
  • Limiter Ratio - infinity:1
  • Limiter Type - PeakStopPlus® two-stage limiter
  • Limiter Stage 1 - PeakStop® brickwall limiter
  • Limiter Stage 1 Attack Time - Zero
  • Limiter Stage 1 Release Time - Zero
  • Limiter Stage 2 Predictive intelligent program limiter
  • Limiter Stage 2 Attack Time - Program-dependent
  • Limiter Stage 2 Release Time - Program-dependent
  • Expander/Gate Threshold Range - Off to +15dBu
  • Expander/Gate Ratio - 1:1 to 30:1
  • Expander/Gate Attack Time -
  • Expander/Gate Release Time - Program-dependent
  • SC Ext. Switch - Routes the external sidechain input signal to the detector
  • SC Mon. Switch - Routes the sidechain signal to the output, interrupting the normal audio
  • OverEasy® Switch - Activates the OverEasy compression function
  • Countour Switch - Activates the frequency-dependent detector function
  • Auto Switch - Activates automatic program-dependent attack and release times, disabling the manual Attack and Release controls
  • I/O Meter Switch - Switches between monitoring input and output levels on the Input/Output Level meter
  • Bypass Switch - Activates the direct input-to-output hard-wire relay bypass. Relay automatically hard-wire bypasses unit at power-down and provides a power-on delay of 1.5 sec.
  • Operating Level Switch - (rear panel) Switches the nominal operating level between -10 dBV and +4 dBu simultaneoulsy for both input and output levels
  • ST Link Switch - Link both channels for stereo operation. Channel One becomes the master
  • Gain Reduction Meter - 12-segment LED bar graph at 1, 2, 4, 6, 9, 12, 15, 18, 21, 24, 27 and 30 dB
  • I/O Meter - 8-segment LED bar graph at -24, -18, -12, -6, 0, +6, +12, and +18 dBu
  • Compressor Threshold Meter - 3-segment LED bar graph at Below (-), OverEasy and Above (+)
  • Expander/Gate Threshold Meter - 2-segment LED bar graph at Below (-) and Above (+)
  • Limiter Threshold Meter - 1 LED to indicate PeakStopPlus? limiting
  • Function Switches - LED indicator for each front-panel switch
  • Output Transformer Options - Jensen® JT-123-dbx or JT-11-dbx, BCI RE-123-dbx or RE-11-dbx
  • Operating Voltage - 100-120 VAC 50/60 Hz 200-240 VAC 50/60 Hz
  • Power Consumption - 20 Watts
  • Fuse - 100-120 VAC:250 mA Slow Blow, 200-240 VAC:125 mA Type T
  • Power Connector - IEC receptacle
  • Dimensions - 1.75"Hx19"Wx9"D (4.4cmx48.3cmx20.1cm)
  • Unit Weight - 5.1 lbs. (2.3 kg)
  • Shipping Weight - 7.5 lbs. (3.4 kg)
  • Selectable auto (classic dbx®) or manual (variable Attack and Release) compression
  • Contour switch removes unwanted low frequency information from detector circuit
  • Selectable Overeasy® or Hard Knee compression modes
  • PeakStopPlus? limiting for setting maximum allowable level with minimal distortion
  • SC Ext and SC Mon for setting up and monitoring external devices for gating function
  • True differentially balanced gold-plated XLR and 1/4" inputs and outputs
  • True RMS level detection
  • Precision metering of input level, output level, and gain reduction
  • True stereo or dual mono operation
  • Switchable +4dBu or -10dBV operation per channel
  • FINANCE CALCULATOR

    Write a review for the DBX 1066

    How do you rate this product? *

    • Quality
      1 1 star
      1 1 star
      1 1 star
      1 1 star
      1 1 star
    • Price
      1 1 star
      1 1 star
      1 1 star
      1 1 star
      1 1 star
    • Value
      1 1 star
      1 1 star
      1 1 star
      1 1 star
      1 1 star

    Seen the DBX 1066 Cheaper?

    Price Match
    We're always competitively priced! However, on the odd occasion a competitor may offer a lower price on a product, all we ask is that the store or website offering the lower price is an authorised dealer for that brand and is based in the UK with the products being 'like for like' and available from stock. We will also take into account any delivery charges.

    * Required Fields